Coin Shooting: Finding Old Coins With a Metal Detector
Coin shooting explained: where to find old coins, which detector and coil to use, the target IDs that mean silver, and the research that fills the pouch.

Coin shooting is metal detecting aimed at coins, and it is how most hobbyists start, because the targets are everywhere people have lived. The skill is not swinging the coil; it is knowing where a century of dropped change collected and reading the signals well enough to dig the old silver and skip the trash.
This guide covers where to hunt, how to set up a detector for coins, which readings mean a keeper, and the research and etiquette that separate full pouches from empty ones. DetectorWise does not field test; detector behavior here follows from maker specs and the detection physics in our how metal detectors work guide.
What is coin shooting and where do you do it?
Coin shooting is detecting specifically for coins, in places where people have gathered for decades. The best sites are old and heavily used: the oldest ground with the most historic foot traffic holds the oldest, most valuable coins.
| Site type | What you find | Why it works |
|---|---|---|
| Old public parks | Silver and copper coins, since the early 1900s | Generations of picnics, fairs and games |
| Old home yards (pre-1950) | Dropped change, early coins | People spent hours in yards before TV |
| School grounds | Coins by the decade | Constant child and event traffic |
| Fairgrounds and churchyards | Coins, tokens | Dense crowds on event days |
| Swimming holes and old beaches | Coins, rings | Loose clothing and water loss |
Modern parks and new subdivisions hold mostly clad coins, which is fine for practice. The old sites are where silver turns up, and finding them is a research task, not a luck one.
Which detector and coil suit coin shooting?
Any VLF detector with stable target IDs and solid discrimination works for coins; the choice comes down to the ground. A smaller coil separates targets in trashy parks, while depth and a larger coil help on long-settled open ground where coins sit deep.
- Trashy parks and yards: a 6 to 9 inch coil, mid to high sensitivity, and a notch or tone break that still lets you check pull-tab-range signals, since early small coins can read low.
- Open old ground: a stock or larger coil for depth, run in a coin or park mode with multi-tone audio.
- Starter setup: a machine like the Garrett ACE 400, Minelab X-Terra Pro or Equinox 700 covers coins well out of the box.
A pinpointer and a proper digger matter as much as the detector for clean recovery, as our pinpointer guide and digging tools guide explain. If you are buying your first machine for parks, our beginner detector guide prices a full kit.
How do you tell a coin from trash by the signal?
Coins give a repeatable, two-way tone and a stable target ID, while most trash reads jumpy or ferrous. The trick is checking a signal from several angles: a good coin holds its number, while a bent can or a nail jumps around.
US coin conductivity runs in a clear order. Nickels read mid, in the pull-tab range, which is the one awkward coin. Zinc pennies read a little higher, copper pennies and dimes higher still, and quarters higher again. Pre-1965 US dimes and quarters are 90 percent silver, a strong high conductor, so they read at the very top, above clad coins. That consistent high silver reading is what lets coin shooters hunt silver by tone alone in a trashy park. The exact numbers differ by brand, so learn your own scale with an air test.
What research finds old coins faster?
Research points the coil at ground that saw foot traffic a century ago, which no amount of random swinging can match. Old maps and aerial photos reveal vanished parks, demolished schools and former gathering spots that now look like empty fields.
- Sanborn fire insurance maps show building footprints and land use from the late 1800s onward.
- Historic topographic maps (USGS) reveal old roads, schools and churches.
- Historic aerial photos show where buildings and paths used to be.
- County histories and old postcards name fairgrounds, picnic groves and swimming holes.
- Plat maps and deeds date when a house or lot was first occupied.
Overlay an old map on a current one, find the spots that were busy then and open now, and confirm you can legally detect there. Permission and legality come first: parks and private land have rules, which our metal detecting laws guide lays out.
How do you dig and refill without losing access?
Cut a neat plug, retrieve the coin with a pinpointer, and replace the plug so the lawn looks untouched. Clean recovery is what keeps parks and private yards open to the next detectorist, and sloppy holes get the hobby banned from a site for everyone.
Work in this order: pinpoint the target, cut a three-sided flap plug with the grass roots intact, fold it back, locate the coin with the pinpointer, lift it, then fold the plug down and press it flat. On bare soil, dig a small cone and tamp the dirt back. Pocket all trash you dig; leaving a rusty bottle cap beside a hole tells a groundskeeper what happened. Refilling well is not optional etiquette, it is how the sites stay huntable.
What timing and conditions help coin shooting?
Hunt after rain and work ground that has just been disturbed, because moisture and fresh exposure can both help. Damp soil usually conducts better, which Minelab says can improve detection depth, so the days after a soaking rain are worth a try in parks and yards. The gain fades once ground turns waterlogged, and wet mineralized soil can add noise.
Other conditions that pay off:
- With the owner’s permission, after construction or demolition near an old site exposes fresh ground.
- Early morning or late in the day, when parks are quiet and you can work carefully.
- Cooler months, when grass is short and the ground is often damp.
A site worked years ago can still produce, because damper soil or a different coil may pick up targets an earlier pass missed. Returning to a known productive park after heavy rain often beats hunting a new site cold, because you already know people once gathered there.
How do you grid a site so you miss nothing?
Work a site in overlapping parallel lanes rather than wandering, so the coil passes over every inch at least once. Old ground gives up coins one hunt at a time, and the coins you walk over today are the ones a gridded return finds next week.
- Pick a reference line, such as a path edge or fence, and sweep parallel to it.
- Overlap each sweep by half a coil width so there are no gaps.
- Move forward slowly, no faster than the coil can resolve one target from the next.
- On a productive patch, cross-grid at 90 degrees to catch targets that hid on the first pass.
Slowing down matters most in trashy ground, where a fast sweep blends a good coin and a nearby nail into one confusing signal.
Who is coin shooting not for?
Hunters chasing gold nuggets, deep relics or beach jewelry need a different approach. Coin shooting rewards patience and research in settled, often trashy ground, not the specialist gear and remote sites those pursuits demand.
If you want natural gold, a high-frequency or pulse induction gold machine and goldfields suit you better. If you want relics, iron-heavy historic sites and deep-seeking setups matter more than coin-grade discrimination. And if you only want to recover one lost ring in your own yard, you do not need the research habit at all. To match a detector to coin shooting in your area, run the Metal Detector Finder.
Sources: USGS Historical Topographic Map Collection, Library of Congress Sanborn Maps, US Mint coin composition and silver content, Minelab, coin hunting knowledge base.
Frequently asked questions
Quick answers to what detectorists ask us most
What is coin shooting in metal detecting?
Coin shooting is detecting with the goal of finding coins rather than relics, gold or jewelry. Hunters target places where people gathered and dropped change over decades, such as parks, fairgrounds, old schools and front yards of old houses, and prize older silver and copper coins.
Where are the best places to coin shoot?
Old gathering spots: century-old parks, fairgrounds, churchyards with permission, swimming holes, school grounds, and the yards of houses built before 1950. The oldest ground that saw the most foot traffic holds the oldest coins, which is why research beats random swinging.
What detector is best for coin shooting?
Any detector with stable target IDs and good discrimination works. A single-frequency or multi-frequency VLF such as the Garrett ACE 400, Minelab X-Terra Pro or Equinox series suits coins well. A smaller coil helps in trashy parks; depth matters on long-settled ground.
What do silver coins read on a metal detector?
High. Pre-1965 US dimes and quarters are 90 percent silver and are strong high conductors, reading near the top of the scale, above most copper coins. That consistent high reading is what lets coin shooters hunt silver by tone in trashy sites.
How deep do old coins get buried?
Roughly an inch per few decades in undisturbed soil, so century-old coins often sit 6 to 10 inches down. That depth is why coin shooters value machines and coils that hold a stable ID deep, and why they learn how their IDs fade with depth.